Master Cylinder: Installation

WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Install the master cylinder to vehicle, and connect the clutch pipe to master cylinder.
NOTE: Check that the pipe is routed properly.

Tightening torque:

T1: 15 N.m (1.5 kgf-m, 10.8 ft-lb)

T2: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 1: Installing Master Cylinder To Vehicle
Courtesy of SUBARU OF AMERICA, INC.
Connect the push rod of master cylinder to clutch pedal, and install the clevis pin and snap pin.
NOTE: Apply grease to the clevis pin.

Fig 2: Applying Grease To Clevis Pin
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the clutch system, ensure that clutch operates properly. < Ref. to , CLUTCH FLUID AIR BLEEDING . >
Install the air intake chamber. < Ref. to INSTALLATION , Air Intake Chamber. >