Mode $02 (Powertrain Freeze Frame Data)
WARNING: This page is about a different car, the 2005 Subaru Outback and 2005 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
Refer to data denoting the operating condition when trouble is detected by the on-board diagnosis system. A list of the support data and PID (Parameter Identification) codes are shown in SUPPORT DATA AND PID (PARAMETER IDENTIFICATION) CODES LIST (MODE $02) .
SUPPORT DATA AND PID (PARAMETER IDENTIFICATION) CODES LIST (MODE $02)
| PID | Data | Unit of measure |
|---|---|---|
| 02 | DTC that caused CARB required freeze frame data storage | - |
| 03 | Fuel system control status | - |
| 04 | Calculated engine load value | % |
| 05 | Engine coolant temperature | °C |
| 06 | Short term fuel trim (Bank 1 Sensor 1) | % |
| 07 | Long term fuel trim (Bank 1 Sensor 1) | % |
| 0B | Intake manifold absolute pressure | kPa |
| OC | Engine speed | RPM |
| OD | Vehicle speed | MPH |
| OE | Ignition timing advance | ° |
| OF | Intake air temperature | °C |
| 10 | Air flow rate from mass air flow sensor | g/sec |
| 11 | Throttle valve opening angle | % |
| 13 | Check whether oxygen sensor is installed. | - |
| 15 | Oxygen sensor output voltage and short term fuel trim associated with oxygen sensor (Bank 1 Sensor 2) | V and % |
| 1C | Supporting OBD system | - |
NOTE:
Refer to OBD-II general scan tool manufacturer's operation manual to access freeze frame data (MODE $02).