Main Shaft Assembly: Adjustment

WARNING: This page is about a different variant/trim than selected.

Selection of main shaft rear plate:

Using the ST, measure the amount (A) of ball bearing protrusion from transmission main case surface and select the proper plate in the following table:

NOTE: Before measuring, tap the end of main shaft with a plastic hammer lightly in order to make the clearance zero between the main case surface and the moving flange of bearing.

ST 498147000 DEPTH GAUGE

Fig 1: Ball Bearing Protrusion Dimension Chart

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Measuring Amount Of Ball Bearing Protrusion From Transmission Main Case Surface

Courtesy of SUBARU OF AMERICA, INC.