Steering Wheel: Installation
NOTE:
Roll connector is also known as Clockspring.
- Align center of roll connector. Refer to CLOCKSPRING , ADJUSTMENT .
- Install in the reverse order of removal.
NOTE:
Align matching marks on steering wheel and steering column.
- Tightening torque: 4.5 N.m (4.5 kgf-m, 32.5 ft-lb)
- Column cover-to-steering wheel clearance: 2 - 4 mm (0.08 - 0.16 in)
WARNING:
Always refer to AIR BAG RESTRAINT SYSTEMS
before performing airbag module service (if so equipped).
.
CAUTION:
Insert roll connector guide pin into guide hole on lower end of surface of steering wheel to prevent damage. Draw out airbag system connector, horn connector and cruise control connectors from guide hole of steering wheel lower end.