Master Cylinder: Installation

WARNING: This page is about a different variant/trim than selected.

Install the master cylinder to body, and install the clutch pipe to master cylinder.
NOTE: Check that the pipe is routed properly.

Tightening torque:

T1: 15 N.m (1.5 kgf-m, 10.8 ft-lb)

T2: 18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 1: Installing Master Cylinder To Body
Courtesy of SUBARU OF AMERICA, INC.
Connect the push rod of master cylinder to clutch pedal, and install the clevis pin and snap pin.
NOTE: Apply grease to the clevis pin.

Fig 2: Applying Grease To Clevis Pin Of Push Rod
Courtesy of SUBARU OF AMERICA, INC.
After bleeding air from the system, ensure that clutch operates properly.
< Ref. to CLUTCH FLUID AIR BLEEDING .>
Install the air cleaner case and air intake duct (Non-turbo model). < Ref. to INSTALLATION . > and < Ref. to INSTALLATION . >
Install the intercooler (Turbo model). < Ref. to INSTALLATION , Intercooler. >