LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2004 >> Forester XT, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (A/T Control Systems) >> Select Cable >> Removal

Select Cable: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
  3. Prior to removal, set the lever to "N" range.
  4. Lift-up the vehicle.
  5. Remove the front and center exhaust pipe.

    Non-turbo model 

    < Ref. to REMOVAL , Front Exhaust Pipe . >

    Turbo model 

    < Ref. to REMOVAL , Front Exhaust Pipe . >

  6. Remove the heat shield cover. (If equipped)
  7. Remove the snap pin from range select lever.
    Fig 1: Identifying Select Cable
    G00937563Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the plate assembly from transmission case.
    Fig 2: Identifying Plate Assembly
    G00937564Courtesy of SUBARU OF AMERICA, INC.
  9. Disconnect the select cable from range select lever, and then remove the cable bracket.
    Fig 3: Disconnecting Select Cable From Range Select Lever, And Identifying Cable Bracket
    G00937565Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the select cable from plate assembly.
scientia non olet · About LEMON Manuals