Cruise Control System: Actuator: Installation
Install in the reverse order of removal.
Tightening torque:
Actuator:
7.4 N.m (0.75 kgf-m, 5.4 ft-lb)
Cable end nut:
12 N.m (1.2 kgf-m, 8.7 ft-lb)
NOTE:
- Must be adjusted when the cable end outer is fixed in place, so that gap between throttle cam and lever is 0 - 1 mm (0 -0.04 in), otherwise, inner cable deflection (D) is 1 - 8 mm (0.039 - 0.315 in) when the throttle cable is installed.
(Must be attached while the throttle cam is being pulled by wire cable.)
- Must be coated evenly on the cam end inner connection.
- Cover must be inserted securely, until tip of cable touches cover stopper.