Code 65

WARNING: This page is about a different car, the 2003 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Before proceeding, see AIR BAG SAFETY PRECAUTIONS . After repairs are complete, check AIR BAG warning light to verify system is functioning correctly. See SYSTEM OPERATION CHECK .

Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Disconnect connector AB20 from right seat belt pretensioner. See SEAT BELT PRETENSIONERS under REMOVAL & INSTALLATION. Connect test harness "F" (98299FC010), connector 1F to connector AB20. See Figure. Connect Air Bag Resistor (98299PA040) to test harness "F", connector 3F. See Figure. Connect negative battery cable and turn ignition switch on (with engine off). If AIR BAG warning light turns off after 6 seconds, replace seat belt pretensioner. If AIR BAG warning light does not turn off after 6 seconds, go to next step.
Turn ignition off. Disconnect negative battery cable and wait at least 20 seconds. Disconnect air bag resistor from test harness "F". Disconnect connector AB11 from side air bag module, located under seat. See Figure. Disconnect connectors AB7 and AB8 from air bag control module. See AIR BAG CONTROL MODULE under REMOVAL & INSTALLATION. See Figure. Connect test harness "R" (98299FE030), connector 1R to connector AB8. See Figure. Measure voltage between ground and test harness "R", connector 3R, terminal No. 17. Measure voltage between ground and test harness "R", connector 3R, terminal No. 19. If voltage is less than one volt, replace air bag control module. If voltage is more than one volt, replace side air bag harness and body harness.