LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Outback L.L. Bean Edition >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical (H4SO)) >> Valve Rocker Assembly >> Installation

Valve Rocker Assembly: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Installation of valve rocker assembly
    1. Temporarily tighten bolts (a) through (d) equally as shown in figure.
      NOTE: Do not allow valve rocker assembly to gouge knock pins.
    2. Tighten bolts (e) through (h) to specified torque.
    3. Tighten bolts (a) through (d) to specified torque.
    1. Tightening torque:  25 N.m (2.5 kgf-m, 18.1 ft-lb)
    Fig 1: Tightening Valve Rocker Bolt
    G02875329Courtesy of SUBARU OF AMERICA, INC.
  2. Adjust the valve clearances. See ADJUSTMENT , Valve Clearances.
  3. Install rocker cover. Tightening torque:  5 N.m (0.5 kgf-m, 3.6 ft-lb). Connect PCV hose.
  5. Install camshaft sprocket. See INSTALLATION , Camshaft Sprockets.
  6. Install timing belt assembly. See INSTALLATION , Timing Belt Assembly.
  7. Install belt cover. See INSTALLATION , Belt Cover.
  8. Install crankshaft pulley. See INSTALLATION , Crankshaft Pulley.
  9. Install V-belt. See INSTALLATION , V-belt.
scientia non olet · About LEMON Manuals