LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Outback Base, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Fuel Injection (Fuel Systems, H6DO)) >> Knock Sensor >> Installation

Knock Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install knock sensor to cylinder block.
    1. Tightening torque:  25 N.m (2.5 kgf-m, 18 ft-lb)
    NOTE: For the knock sensor's installation angle, refer to, See Fig 1.
    Fig 1: Installing Knock Sensor To Cylinder Block
    G02877124Courtesy of SUBARU OF AMERICA, INC.
  2. Connect knock sensor connector.
  3. Install intake manifold. < Ref. to INSTALLATION , Intake Manifold.>
  4. Connect battery ground cable.
    Fig 2: Connecting Battery Ground Cable
    G02877125Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals