Front Knuckle/Hub: Disassembly
WARNING: This page is about a different car, the 2003 Subaru Impreza and 2002 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
- Using hub remover, support housing and hub securely.CAUTION: Be careful not to scratch polished area of hub. Be sure to install inner race on the side of outer race from which it was removed. See Fig 2.
- Attach hub stand to housing and drive hub out. See Fig 1. If inner bearing race remains in the hub, remove it with appropriate tool.
- Remove disc cover from housing. See Fig 3.CAUTION: DO NOT use old oil seals.
- Using a standard screwdriver, remove outer and inner oil seals.CAUTION: Be careful not to damage housing at removal.
- Using flat bladed screwdriver, remove snap ring. See Fig 4.
- Using housing stand, support housing securely.CAUTION:
- DO NOT remove outer race unless it is faulty.
- Discard outer race after removal.
- DO NOT replace inner or outer race separately; always replace as a unit.
- Using bearing puller, press inner race to drive out outer bearing. See Fig 5.CAUTION: Be careful not to hammer hub bolts. This may deform hub.
- Using hub stand and a hydraulic press, drive hub bolts out. See Fig 6.