LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Impreza TS, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake Systems >> Abs Sequence Control >> Operation >> Abs Sequence Control With Select Monitor

Abs Sequence Control With Select Monitor

NOTE:
  • In the event of any trouble, the sequence control may not be operative. In such a case active the sequence control, see ABS SEQUENCE CONTROL WITH DIAGNOSIS CONNECTOR  , OPERATION, ABS Sequence Control.
  • When the diagnosis terminal is connected to the diagnosis connector, the sequence control will not operate.
  1. Connect the select monitor to data link connector under the driver's seat instrument panel lower cover.
  2. Turn the ignition switch to ON.
  3. Turn the select monitor switch to ON.
  4. Put the select monitor to "BRAKE CONTROL" mode.
  5. When "Function check sequence" is selected, `ABS sequence control' will start.
  6. The message `Press Brake Pedal Firmly' is displayed as follows:
    1. When using the brake tester, depress the brake pedal with braking force of 1,000 N (100 kgf, 221 lb).
    2. When using the pressure gauge, depress the brake pedal so as to make the pressure gauge indicate 3,500 kPa (35 kg/cm2 , 498 psi).
    CAUTION: Do not depress the clutch pedal.
  7. When the message "Press YES" is displayed, press the YES key.
  8. Operation points will be displayed on the select monitor.
scientia non olet · About LEMON Manuals