LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2003 >> Baja Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Trans) >> Reduction Driven Gear >> Removal >> VTD Model

VTD Model

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. < Ref. to REMOVAL , Automatic Transmission Assembly.>
  2. Remove rear vehicle speed sensor, and separate the transmission case and extension case.

    < Ref. to REMOVAL , Extension Case.>

  3. Remove the rear drive shaft. < Ref. to REMOVAL , Rear Drive Shaft.>
  4. Set the range select lever to "P".
  5. Straighten the staked portion, and remove the lock nut.
    Fig 1: Removing Lock Nut
    G02875931Courtesy of SUBARU OF AMERICA, INC.
  6. Using the ST1 and ST2, extract the reduction driven gear.
    1. ST1 499737000 PULLER
    2. ST2 899524100 PULLER SET
  7. Pull out the center differential assembly. < Ref. to REMOVAL , Center Differential Carrier.>
scientia non olet · About LEMON Manuals