VTD Model

WARNING: This page is about a different variant/trim than selected.

Set the select lever to "P" range.
Using a plastic hammer, install reduction driven gear assembly.
Using a plastic hammer, install the center differential assembly.
Install a new self-lock nut and a washer.
1. Tightening torque: 100 N.m (10.2 kgf-m, 73.8 ft-lb)
  
  Fig 1: Installing Self-Lock Nut & Washer
  Courtesy of SUBARU OF AMERICA, INC.
After tightening, stake the lock nut securely.
Insert the rear drive shaft assembly. < Ref. to INSTALLATION , Rear Drive Shaft.>
Combine the transmission case with the extension case, and install rear vehicle speed sensor.
< Ref. to INSTALLATION , Extension Case.>
Install the transmission assembly to vehicle.
< Ref. to INSTALLATION , Automatic Transmission Assembly.>