Select Cable

Select the vehicle on the lift.
Disconnect the ground terminal from battery.
Set the lever to "N" position.
Lift-up the vehicle.
Remove the rear exhaust pipe and muffler.
Remove the heat shield cover. (If equipped)
Loosen the adjusting nut on each side. See Fig 1 .
Turn the adjusting nut "B" until it lightly touches the connector. See Fig 2 .
While preventing the adjusting nut "B" from moving with a wrench, tighten adjusting nut "A". See Fig 3 .
After completion of fitting, make sure that the select lever operates smoothly all across the operating range.
Install in the reverse order of removal.

Fig 1: Disconnecting Cable From Select Lever

Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Turning Adjusting Nut "B"

Courtesy of SUBARU OF AMERICA, INC.

Fig 3: Tightening Adjusting Nut "A"

Courtesy of SUBARU OF AMERICA, INC.