LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2002 >> Impreza Outback Sport, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (A/T Control Systems) >> Select Lever >> Removal

Select Lever: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Set the vehicle on the lift.
  2. Disconnect the ground terminal from battery.
  3. Move the select lever to the "N" position.
  4. Lift-up the vehicle.
  5. Remove the rear exhaust pipe and muffler.
  6. Remove the heat shield cover. (If equipped)
  7. Disconnect the cable from select lever and then remove the cable bracket.
    Fig 1: Disconnecting Cable From Select Lever And Removing Cable Bracket
    G02871519Courtesy of SUBARU OF AMERICA, INC.
  8. Lower the vehicle.
  9. Remove the console box. < Ref. to REMOVAL , Console Box. >
  10. Disconnect the connectors, then remove the four bolts to take out the select lever assembly from the body.
    Fig 2: Removing Bolts To Take Out Select Lever Assembly From Body
    G02871520Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals