Removal & Installation: Strut: Installation

CAUTION: Use a new self-locking nut.

Install strut mount cap.
NOTE: Tighten strut mount and cap as a unit.
Tighten self locking nut used to secure strut mount to vehicle. See TORQUE SPECIFICATIONS .
Tighten bolts securing rear strut to housing.
1. Models with rear disc brakes:
  Tighten brake hose union bolt on brake caliper.
2. Models with rear drum brakes:
  Connect brake hose union bolt on brake caliper.
CAUTION:
- Check that hose clip is positioned properly.
- Check brake hose for twisting,or excessive tension.
- DO NOT subject ABS sensor harness to excessive tension.
Insert brake hose clip between brake hose and lower side of strut.
Be sure to bleed air from brake system. See AIR BLEEDING, BR-42 .
Lower vehicle and tighten wheel nut. See TORQUE SPECIFICATIONS .
NOTE: Check wheel alignment and adjust if necessary.
Install strut cap of rear quarter trim.