LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2002 >> Forester Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (Automatic Transmission) >> Reduction Driven Gear >> Installation

Reduction Driven Gear: Installation

WARNING: This page is about a different car, the 2003 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the select lever to "P" range.
  2. Using a plastic hammer, install reduction driven gear assembly and new washer, and tighten new drive pinion lock nut.
    1. Tightening torque:  100 N.m (10.2 kgf-m, 73.8 ft-lb)
    Fig 1: Installing Reduction Driven Gear Assembly
    G02093194Courtesy of SUBARU OF AMERICA, INC.
  3. After tightening, stake the lock nut securely.
  4. Combine the transmission case with the extension case, and install rear vehicle speed sensor. Refer to INSTALLATION .
  5. Install the transmission assembly to vehicle. Refer to INSTALLATION , Automatic Transmission Assembly.
scientia non olet · About LEMON Manuals