Roof Molding: Installation

WARNING: This page is about a different car, the 2004 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Remove the clip of roof and rear pillar (sedan model) from roof molding, and then install it to body side.
CAUTION: Make sure to replace the clips broken when removing the roof molding with new ones.

Fig 1: Locating Clip Installing Position
Courtesy of SUBARU OF AMERICA, INC.
Put the front edge of roof molding onto front window molding, and insert the front locating pin into body side cap.

Fig 2: Identifying Front Window, Locating Pin, Roof Molding, Cap & Clip
Courtesy of SUBARU OF AMERICA, INC.
Install the roof molding to body, by pushing the roof molding from above being careful not to deform it.