Fuel Pump: Removal

WARNING: This page is about a different car, the 2004 Subaru Outback, 2004 Subaru Legacy, and 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Place "NO FIRE" signs near the working area.
Be careful not to spill fuel on the floor.

NOTE: Fuel pump assembly consists of fuel pump and fuel level sensor.

Release fuel pressure. Refer to RELEASING OF FUEL PRESSURE , OPERATION, Fuel.
Drain fuel from tank. Refer to DRAINING FUEL , OPERATION, Fuel.
Raise rear seat and turn floor mat up.
Remove access hole lid.

Fig 1: Removing Rear Seat & Turning Floor Mat Up
Courtesy of SUBARU OF AMERICA, INC.
Disconnect connector from fuel pump.

Fig 2: Removing Connector From Fuel Pump
Courtesy of SUBARU OF AMERICA, INC.
Disconnect quick connector and then disconnect fuel delivery hose (A) and return hose (B). Refer to REMOVAL , Fuel Delivery, Return and Evaporation Lines.

Fig 3: Removing Quick Connector And Fuel Delivery Hose And Return Hose
Courtesy of SUBARU OF AMERICA, INC.
Remove nuts which install fuel pump assembly onto fuel tank.

Fig 4: Removing Nuts Installing Fuel Pump Assembly Onto Fuel Tank
Courtesy of SUBARU OF AMERICA, INC.
Take off fuel pump assembly from fuel tank.