Transfer Clutch: Disassembly

WARNING: This page is about a different car, the 2004 Subaru Outback, 2004 Subaru Legacy, and 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.

Remove the seal ring.

Fig 1: Removing Seal Ring
Courtesy of SUBARU OF AMERICA, INC.
Using a press and ST, remove the ball bearing.

Fig 2: Removing Ball Bearing Using Special Tool
Courtesy of SUBARU OF AMERICA, INC.
Remove the snap ring, and take out the pressure plate, drive plates, and driven plates.

Fig 3: Removing Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Remove the snap ring with ST1, ST2 and ST3, and take out the return spring and transfer clutch piston seal.

Fig 4: Removing Snap Ring With ST1, ST2 & ST3
Courtesy of SUBARU OF AMERICA, INC.
Apply compressed air to the rear drive shaft to remove the piston.

Fig 5: Applying Compressed Air To Rear Drive Shaft
Courtesy of SUBARU OF AMERICA, INC.