LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2001 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 169 (Engine (Diagnostics) (H4SO)) >> Clear Memory Mode >> Operation >> SUBARU Select Monitor (Normal Mode)

SUBARU Select Monitor (Normal Mode)

WARNING: This page is about a different car, the 2004 Subaru Outback, 2004 Subaru Legacy, and 2004 Subaru Baja. However, it is still accessible from the selected car via links, so may be relevant.
  1. On the << Main Menu >> display screen, select the {Each System Check} and press the [YES] key.
  2. On the << System Selection Menu >> display screen, select the {Engine Control System} and press the [YES] key.
  3. Press the [YES] key after displayed the information of engine type.
  4. On the << Engine Diagnosis >> display screen, select the {Clear Memory} and press the [YES] key.
  5. When the `Done' and `Turn Ignition Switch OFF' are shown on the display screen, turn the Subaru Select Monitor and ignition switch to OFF.
    NOTE:
    • After the memory has been cleared, the ISC must be initialized. To do this, turn the ignition switch to the ON position. Wait 3 seconds before starting the engine. (AT vehicles only).
    • For detailed operation procedure, refer to the Subaru Select Monitor Operation Manual.
scientia non olet · About LEMON Manuals