LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2001 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Automatic Transmission (On-Vehicle Service)) >> Inhibitor Switch >> Installation

Inhibitor Switch: Installation

WARNING: This page is about a different car, the 2002 Subaru Outback and 2002 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect inhibitor switch harness connector to inhibitor switch.
  2. Install inhibitor switch to transmission case.
    Fig 1: Installing Inhibitor Switch To Transmission Case
    G02960444Courtesy of SUBARU OF AMERICA, INC.
  3. Move range select lever to neutral position.
  4. Using ST, tighten bolts of inhibitor switch.
    Fig 2: Tightening Bolts Of Inhibitor Switch
    G02960445Courtesy of SUBARU OF AMERICA, INC.
  5. Install select cable to range select lever.
  6. Install plate assembly to transmission.
    Fig 3: Installing Plate Assembly To Transmission
    G02960446Courtesy of SUBARU OF AMERICA, INC.
  7. Install snap pin to range select lever.
    Fig 4: Installing Snap Pin To Range Select Lever
    G02960447Courtesy of SUBARU OF AMERICA, INC.
  8. Install front exhaust pipe and center exhaust pipe.

    Refer to INSTALLATION , Front Exhaust Pipe. (2.5L Model)

    Refer to INSTALLATION , Front Exhaust Pipe. (3.0L Model)

  9. Connect inhibitor switch connector.
    Fig 5: Connecting Inhibitor Switch Connector
    G02960448Courtesy of SUBARU OF AMERICA, INC.
  10. Install air cleaner case or air intake chamber.

    Refer to INSTALLATION , Air Cleaner Case.

    Refer to INSTALLATION , Air Intake Chamber. (3.0L Model)

  11. Inspect inhibitor switch. Refer to INSPECTION  , Inhibitor Switch.
scientia non olet · About LEMON Manuals