Idle Speed
NOTE:
Idle speed for 3.0L engine must be checked using a scan tool.
- Ensure air filter is clean, vacuum hoses are properly routed and connected, spark plugs are in good condition and timing is at specification. See IGNITION TIMING . Verify Malfunction Indicator Light (MIL) is not illuminated. Warm engine to normal operating temperature. Turn ignition off. Connect scan tool or secondary pick-up type tachometer following manufacturer's instructions.
- Start and idle engine. Check idle speed with accessories off, then with A/C on. See IDLE SPEED SPECIFICATIONS table. If idle speed is not as specified, perform Basic Diagnostic Procedure. See SELF-DIAGNOSTICS article. Repair as necessary.
NOTE:
Because spark plugs No. 1 and 2 fire simultaneously, some tachometers may register twice actual engine speed.
IDLE SPEED SPECIFICATIONS
| Application | RPM | ||
|---|---|---|---|
| Forester, Impreza & Outback Sport | |||
| With A/C Off | |||
| A/T | 600-800 | ||
| M/T | 550-750 | ||
| With A/C On | 800-900 | ||
| Legacy & Outback 2.5L | |||
| With A/C Off | |||
| A/T | 600-800 | ||
| M/T | 550-750 | ||
| With A/C On | 750-950 | ||
| Outback 3.0L | |||
| With A/C Off | 550-650 | ||
| With A/C On | 650-750 | ||