LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2001 >> Impreza Outback Sport, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Braking System >> Front Abs Sensor >> Installation

Front Abs Sensor: Installation

  1. Temporarily install front ABS sensor on housing.
    CAUTION: Be careful not to strike ABS sensor's pole piece and tone wheel's teeth against adjacent metal parts during installation.
    Fig 1: Installing Front ABS Sensor On Housing
    G02193243
  2. Install front ABS sensor on strut and wheel apron bracket.
    1. Tightening torque:  32 N.m (3.3 kgf-m, 24 ft-lb)
    Fig 2: Installing Front ABS Sensor Harness & Wheel Apron Bracket
    G02193244
  3. Place a thickness gauge between ABS sensor's pole piece and tone wheel's tooth face. After standard clearance is obtained over the entire perimeter, tighten ABS sensor on housing to specified torque.
  1. ABS sensor standard clearance:  0.3 - 0.8 mm (0.012 - 0.031 in)
  2. Tightening torque:  32 N.m (3.3 kgf-m, 24 ft-lb)
CAUTION: Check the marks on the harness to make sure that no distortion exists. (RH: white, LH: yellow)
NOTE: If the clearance is outside specifications, readjust.
scientia non olet · About LEMON Manuals