Removal & Installation: Strut: Installation

Install strut mount cap.
CAUTION: Use a new self-locking nut.

NOTE: Tighten strut mount and cap as a unit.
Tighten self-locking nut used to secure strut mount to vehicle body. See TORQUE SPECIFICATIONS .
Tighten bolts securing rear strut to housing.
1. Models with rear disc brakes:
  Tighten brake hose union bolt on brake caliper.
2. Models with rear drum brakes:
  Connect brake hose to brake pipe.
CAUTION:
- Check that hose clip is positioned properly.
- Check brake hose for twisting, or excessive tension.
- DO NOT subject ABS sensor harness to excessive tension.
Insert brake hose clip between brake hose and lower side of strut.
Be sure to bleed air from brake system.
Lower vehicle and tighten wheel nut.
NOTE: Check wheel alignment and adjust if necessary.
Install strut cap of rear quarter trim.