Removal & Installation: Knuckle/Hub: Installation

1. Install transverse link ball joint to housing.
   CAUTION: Use new self-locking nut.
2. While aligning alignment mark on camber adjusting bolt head, connect housing and strut.
3. Install ABS sensor on housing.
4. Install ABS sensor harness on housing.
5. Install disc rotor on hub.
6. Install disc brake caliper on housing.
7. Install front axle shaft.
8. Connect stabilizer link.
9. Install tie-rod end ball join on housing knuckle arm. See Figure .
   CAUTION:

   • Use a new axle nut.
   • Always tighten axle nut before installing wheel on vehicle. If wheel is installed and comes in contact with ground when axle nut is loose, wheel bearings may be damaged.
   • Be sure to tighten axle nut to specification. See TORQUE SPECIFICATIONS  . DO NOT overtighten it as this may damage wheel bearing.
10. While depressing brake pedal, tighten axle nut and lock it securely.
11. After tightening axle nut, lock it securely. See Fig 1 .
12. Install wheel and tighten wheel nuts to specification. See TORQUE SPECIFICATIONS  .

Fig 1: Locking Axle Nut Securely

Courtesy of SUBARU OF AMERICA, INC.