LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Overhaul & Servicing) >> Main Shaft Assembly >> Installation

Main Shaft Assembly: Installation

WARNING: This page is about a different car, the 2001 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the needle bearing and oil seal onto the front of transmission main shaft assembly.
    CAUTION:
    • Wrap clutch splined section with vinyl tape to prevent damage to oil seal.
    • Apply grease (Unilube #2 or equivalent) to the sealing lip of oil seal.
    • Use a new one.
    NOTE:
    • Align the end face of seal with surface (A) when installing oil seal.
      Fig 1: Aligning End Face Of Seal With Surface (A)
      G02060226
    • Be careful not to drop oil seal when installing transmission main case.
    • Make sure straight pin is positioned in hole in needle bearing's outer race.
  2. Install the drive pinion assembly. See INSTALLATION - DRIVE PINION SHAFT ASSEMBLY  .
  3. Install transmission case. See INSTALLATION - TRANSMISSION CASE  .
  4. Install transfer case and extension case assembly. See INSTALLATION - TRANSFER CASE AND EXTENSION CASE ASSEMBLY  .
  5. Install back-up light switch and neutral position switch.
  6. Install the manual transmission assembly to vehicle. See INSTALLATION - TRANSMISSION TO ENGINE  .
scientia non olet · About LEMON Manuals