LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 37 (Power Assisted Steering) >> Oil Pump >> Removal >> 3.0 L Model

3.0 L Model

WARNING: This page is about a different car, the 2001 Subaru Outback and 2001 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove ground cable from battery.
  2. Remove pulley belt cover.
  3. Remove V-belt.
  4. Disconnect connector from power steering pressure switch.
  5. Remove tensioner adjuster.
  6. Disconnect pressure hose and suction hose from oil pump.
    CAUTION:
    • Do not allow fluid from the hose end to come into contact with pulley belt.
    • To prevent foreign matter from entering the hose, cover the open ends of them with a clean cloth.
    Fig 1: Disconnect Pressure & Suction Hose From Oil Pump
    G02111148
  7. Remove bolts, which install power steering pump bracket.
    Fig 2: Removing Power Steering Pump Bracket Bolts
    G02111149
  8. Place oil pump bracket in a vise, remove two bolts from the front side of oil pump.
    CAUTION: Do not place oil pump bracket directly in the vise; use soft pads and hold oil pump lightly to protect the pump.
    Fig 3: Removing Two Bolts From The Front Side Of Oil Pump
    G02111150
  9. Remove bolt from the rear side of oil pump.
  10. Remove oil pump from bracket.
scientia non olet · About LEMON Manuals