LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (On-Vehicle Service & Testing) >> Oil Seal >> Replacement

Oil Seal: Replacement

WARNING: This page is about a different car, the 2001 Subaru Outback and 2001 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean transmission exterior.
  2. Drain ATF completely.
    NOTE: Tighten ATF drain plug after draining ATF.

    Tightening torque: 

    1. 25 N-m (2.5 kgf-m, 18.1 ft-Ib)  . Locate ATF Drain Plug. See Figure.
  3. Remove the rear exhaust pipe and muffler.
  4. Remove the heat shield cover.
  5. Remove the propeller shaft. See REMOVAL, DISASSEMBLY, REASSEMBLY & INSTALLATION .
  6. Using ST, remove the oil seal. ST 398527700 PULLER ASSY
  7. Using ST, install the oil seal. ST 498057300 INSTALLER
  8. Install the propeller shaft. See REMOVAL, DISASSEMBLY, REASSEMBLY & INSTALLATION .
  9. Install the heat shield cover.
  10. Install the rear exhaust pipe and muffler.
  11. Pour ATF and check the ATF level. See Automatic Transmission Fluid .
scientia non olet · About LEMON Manuals