LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2000 >> Outback Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (Overhaul Automatic Transmission) >> Transfer Clutch >> Disassembly

Transfer Clutch: Disassembly

WARNING: This page is about a different car, the 2001 Subaru Outback, 2001 Subaru Legacy, 2001 Subaru Impreza, and 2001 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the seal ring.
    CAUTION: Be careful not to damage the seal ring.
    Fig 1: Removing Seal Ring
    G02053109
  2. Using a press and ST, remove the ball bearing.
    CAUTION: Do not reuse the bearing.

    ST 498077600 REMOVER

    Fig 2: Removing Ball Bearing
    G02053110
  3. Remove the snap ring, and take out the pressure plate, drive plates, and driven plates.
    Fig 3: Removing Snap Ring For Clutch Plates
    G02053111
  4. Remove the snap ring with ST1, ST2 and ST3, and take out the return spring and transfer clutch piston seal.

    ST1 399893600 PLIERS

    ST2 398673600 COMPRESSOR

    ST3 398623600 SEAT

    Fig 4: Removing Snap Ring For Return Spring & Transfer Clutch Piston Seal
    G02053112
  5. Apply compressed air to the rear drive shaft to remove the piston.
    Fig 5: Removing Piston
    G02053113
scientia non olet · About LEMON Manuals