LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1995 >> Impreza Outback, 2.2 4 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes >> Diagnostic Code Testing (OBD - 1.8L) >> Code 35 - Purge Control Solenoid Valve

Code 35 - Purge Control Solenoid Valve

NOTE: Refer to illustration for connector and terminal identification. See Figure -Figure .
  1. Turn ignition on. Measure voltage between ECM connector E30, terminal No. 19 (backprobe) and ground. If voltage is 10-13 volts, repair ECM harness connector or replace ECM. If voltage is not 10-13 volts, go to next step.
  2. Turn ignition off. Disconnect purge control solenoid valve. Measure resistance between solenoid valve terminals. Resistance should be 36 ohms at 68°F (20°C). If resistance is not to specification, replace purge control solenoid valve. If resistance is to specification, go to next step.
  3. Turn ignition on. Measure voltage between purge control solenoid valve connector terminal No. 1 (Yellow/Red wire) and ground. If about 10 volts are present, repair or replace harness connector between ECM and purge control solenoid valve. If about 10 volts are not present, repair or replace power supply circuit.
scientia non olet · About LEMON Manuals