LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1991 >> XT Standard >> Repair and Diagnosis >> Electrical >> Starter - Reduction Gear >> On-Vehicle Testing >> Ignition Switch Test >> Start Circuit Test

Start Circuit Test

  1. Remove lower instrument panel below steering wheel. Remove air duct. Remove harness connector from rear of ignition switch.
  2. Using jumper wire, apply 12 volts to ignition switch terminal "B". Connect test light to switch terminal "S". Turn ignition switch to START position. If test light does not illuminate, replace relay.
scientia non olet · About LEMON Manuals