LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1991 >> XT Automatic >> Repair and Diagnosis (Single Page) >> Electrical >> Starter - Reduction Gear >> Bench Testing >> Lock Test

Lock Test

  1. Using proper starter bench tester, connect test equipment and lock starter armature. Engage tester momentarily while measuring starter torque, current draw and voltage drop.
  2. Check specifications for minimum torque, voltage drop (minimum volts) and current draw (maximum amps). See STARTER SPECIFICATIONS  table at end of article.
  3. Low current draw and no torque during lock test may be caused by excessive resistance between brushes and commutator. Normal current draw but low torque speed may be caused by a shorted commutator and/or poor insulation.
scientia non olet · About LEMON Manuals