LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1991 >> Justy Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Servicing - M/T) >> Adjustments >> High/Low Shifter Rod >> Dual Range Models

Dual Range Models

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1988 Subaru XT6, 1988 Subaru XT, 1988 Subaru RX, 1988 Subaru Justy, and 1988 Subaru GL-10. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove 4 bolts retaining transfer cover and remove cover. Move High/Low shifter rod to the "LO" position and insert Stopper Pin (499267000) into bore of transfer case and high/low shifter rod. See Fig 1 .
  2. Loosen shifter rod adjustment lock nuts. While preventing front rod ball joint from turning, turn rod adjusting screw counterclockwise (as viewed from rear of screw). Back off rod adjusting screw 90 degrees from point at which rod is hard to move. Tighten lock nuts. See Fig 2 .
  3. Remove stopper pin and check for proper operation of shifter rod. Install transfer cover with new gasket and tighten bolts to 11 ft. lbs. (15 N.m).
    Fig 1: Installing Stopper Pin Into High/Low Shifter Rod
    G100154Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Adjusting High/Low Shifter Rod
    G100155Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals