LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 1989 >> Justy GL, 1.2 7, Automatic CVT >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - ECVT >> Component Disassembly & Reassembly >> Control Valve Body >> Disassembly

Control Valve Body: Disassembly

  1. Remove Control Valve Holder (499205600). Remove pressure guide and spring. DO NOT  adjust pressure regulator guide nut and bolt. Remove line pressure control solenoid valve.
  2. Remove separator plate, steel balls, springs, shift lock valve and straight-pin. Being careful not to remove straight-pin from engine brake valve, remove spring pin from shift cam using Straight-Pin Remover (499905400). Remove shift cam and shift control lever. See Fig 1.
  3. Remove snap ring and engine brake support from engine brake valve. Remove straight-pin using Straight-Pin Remover (499905500). Remove engine brake valve, engine brake lever and shift control pin.
  4. Remove spring pin using pliers, and remove snap ring. Move shaft toward center and remove one end of lever from shaft. Move shaft in away from center and remove shaft from roll assembly. Remove shift lock lever.
  5. Remove side plate, shift control valve, high-speed spring and high-speed support. Remove low-speed spring. Remove spacer, linkage guide, roller assembly and low-speed support. Remove plunger assembly. Remove snap ring and pressure regulator valve. Remove spacer and shift lock piston. See Fig 1.
Fig 1: Exploded View Of Control Valve Assembly
G93D24045Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals