LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2016 >> iM Automatic CVT Trans >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT - Service Information >> Revolution Sensor >> Installation [06/2015 - ] >> Procedure

Installation [06/2015 - ]: Procedure

  1. INSTALL TRANSMISSION REVOLUTION SENSOR (NOUT) 
    1. Apply Toyota Genuine CVT Fluid FE to a new O-ring.
    2. Install the O-ring to the transmission revolution sensor (NOUT).
    3. Install the transmission revolution sensor (NOUT) to the rear transaxle case with the bolt.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    4. Connect the transmission revolution sensor (NOUT) connector.
  2. INSTALL TRANSMISSION REVOLUTION SENSOR (NIN) 
    1. Apply Toyota Genuine CVT Fluid FE to a new O-ring.
    2. Install the O-ring to the transmission revolution sensor (NIN).
    3. Install the transmission revolution sensor (NIN) to the transaxle case with the bolt.

      Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf) 

    4. Connect the transmission revolution sensor (NIN) connector.
  3. INSTALL REAR ENGINE UNDER COVER LH 

    Refer to PROCEDURE - Step 78

  4. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 79

  5. CHECK DATA LIST 

    Refer to DATA LIST / ACTIVE TEST [06/2015 - ]

scientia non olet · About LEMON Manuals