LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2016 >> iM Automatic CVT Trans >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Relay >> On-Vehicle Inspection [06/2015 - ] >> Procedure

On-Vehicle Inspection [06/2015 - ]: Procedure

  1. INSPECT IG2 RELAY (IG2) 
    GTY447534Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the IG2 relay (IG2).

  2. INSPECT EFI-MAIN RELAY (EFI-MAIN) 
    GTY447534Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the EFI-MAIN relay (EFI-MAIN).

  3. INSPECT INJ RELAY (INJ) 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage not applied between terminals 1 and 2 10 kΩ or higher
      Battery voltage applied between terminals 1 and 2 Below 1 Ω

      If the result is not as specified, replace the INJ relay (IGT/INJ).

      GTY447534Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals