LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2016 >> iM Automatic CVT Trans >> Repair and Diagnosis >> Brakes >> Brakes Control Systems >> Brake Control System - Service Information >> Rear Speed Sensor >> Installation [06/2015 - ] >> Procedure

Installation [06/2015 - ]: Procedure

  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY 
    1. Install the rear axle hub and bearing assembly.

      Refer to PROCEDURE - Step 1

      HINT: 

      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.
      • If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.
  2. INSPECT REAR AXLE HUB BEARING LOOSENESS 

    Refer to PROCEDURE - Step 8

  3. INSPECT REAR AXLE HUB RUNOUT 

    Refer to PROCEDURE - Step 9

  4. CONNECT SKID CONTROL SENSOR WIRE 
    1. Connect the connector to the rear axle hub and bearing assembly.
  5. INSTALL REAR DISC 

    Refer to PROCEDURE - Step 1

  6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY 

    Refer to PROCEDURE - Step 11

  7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY 

    Refer to PROCEDURE - Step 12

  8. INSTALL PARKING BRAKE LEVER PROTECTOR 

    Refer to PROCEDURE - Step 3

  9. ADJUST PARKING BRAKE 

    Refer to ADJUSTMENT [06/2015 - ]

  10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5

  11. INSTALL REAR WHEEL 

    Refer to PROCEDURE - Step 1

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Refer to INITIALIZATION [06/2015 - ]

  13. CHECK FOR SPEED SENSOR SIGNAL 

    Refer to TEST MODE PROCEDURE [06/2015 - ]

scientia non olet · About LEMON Manuals