LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2016 >> iA Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System - Service Information >> Manifold Absolute Pressure Sensor >> Inspection [07/2015 - ] >> Procedure

Inspection [07/2015 - ]: Procedure

  1. INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR 
    1. Voltage Inspection
      1. Connect the techstream to the DLC-2.
      2. Switch the ignition ON (engine off).
      3. Verify that the MAP sensor output voltage (PID: MAP) is within the specification.

        Refer to ON-BOARD DIAGNOSTIC TEST [07/2015 - ]

        Refer to INSPECTION [07/2015 - ] 

        Specification (Reference) 

        GTY485567Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        *a High
        *b Output Voltage
        *c Low
        *d Intake Air Pressure

        If not as specified, replace the MAP sensor/IAT sensor No. 2.

        Refer to REMOVAL [07/2015 - ] 

scientia non olet · About LEMON Manuals