How To Proceed With Troubleshooting [08/2014 - ]

HINT: 

• The ECM of this system is connected to the CAN communication system. Therefore, before starting troubleshooting, be sure to check that there is no trouble in the CAN communication system.

• *: Use the Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. CUSTOMER PROBLEM ANALYSIS 
   1. Refer to the customer problem analysis. Refer to GENERAL INFORMATION [08/2014 - ] .

      NEXT: Go to next step 

3. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

4. CONNECT TECHSTREAM TO DLC3* 

   NEXT: Go to next step 

5. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* 
   1. Refer to the DTC Check/Clear. Refer to DTC CHECK / CLEAR [08/2014 - ] .

      NEXT: Go to next step 

6. VISUAL INSPECTION 

   NEXT: Go to next step 

7. SETTING CHECK MODE DIAGNOSIS* 
   1. Refer to the Check Mode Procedure. Refer to CHECK MODE PROCEDURE [08/2014 - ] .

      NEXT: Go to next step 

8. DTC CHECK* 
   1. Refer to DTC Check/Clear. Refer to DTC CHECK / CLEAR [08/2014 - ] .
      RESULT
      
      

      Result	Proceed to
      DTC not output	A
      DTC output	B

      B → GO TO STEP  13

      A: Go to next step 

9. BASIC INSPECTION 
   1. Refer to Park/Neutral Position Switch. Refer to INSPECTION [08/2014 - ] .
   2. Refer to Shift Lever Assembly. Refer to INSPECTION [08/2014 - ] .

      NG → GO TO STEP  12

      OK: Go to next step 

10. MECHANICAL SYSTEM TEST* 
    1. Refer to the Mechanical System Test. Refer to MECHANICAL SYSTEM TESTS [08/2014 - ] .

       NG → GO TO STEP  12

       OK: Go to next step 

11. HYDRAULIC TEST* 
    1. Refer to the Hydraulic Test. Refer to HYDRAULIC TEST [08/2014 - ] .

       NG → GO TO STEP 12 

       OK → GO TO STEP  14

12. COMPONENT INSPECTION 

    NEXT → GO TO STEP 16 

13. DTC CHART 
    1. Refer to the Diagnostic Trouble Code Chart. Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2014 - ] .

       NEXT: Go to next step 

14. CIRCUIT INSPECTION 

    NEXT: Go to next step 

15. IDENTIFICATION OF PROBLEM 

    NEXT: Go to next step 

16. REPAIR OR REPLACE 

    NEXT: Go to next step 

17. CONFIRMATION TEST 

    NEXT → END