Charging System (Service Information): Generator: Removal: Removal

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
REMOVE ENGINE UNDER COVER RH
REMOVE NO. 2 CYLINDER HEAD COVER . Refer to REMOVAL - Step 1
REMOVE FAN AND GENERATOR V BELT . Refer to REMOVAL - Step 3
REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
1. Remove 2 bolts and remove the engine mounting stay RH.
  
  Fig 1: Identifying Engine Mounting Stay RH Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Place a wooden block on a jack underneath the engine.
  
  Fig 2: Supporting Engine
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 6 bolts and nut and remove the engine mounting insulator sub-assembly RH.
  NOTE:
  Do not remove bolt A.
  
  Fig 3: Identifying Engine Mounting Insulator Sub-Assembly RH Bolts & Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE TRANSVERSE ENGINE MOUNTING BRACKET
1. Remove the 3 bolts and remove the engine mounting bracket.
  
  Fig 4: Identifying Engine Mounting Bracket Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE GENERATOR ASSEMBLY
1. Remove the 2 bolts and remove the fan belt adjusting bar.
  
  Fig 5: Identifying Fan Belt Adjusting Bar Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the terminal cap.
  
  Fig 6: Identifying Connector & Harness Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the nut and remove terminal B.
4. Disconnect the connector and harness clamp.
5. Remove the bolt and remove the generator assembly.
  
  Fig 7: Identifying Generator Assembly Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Remove the bolt and remove the wire harness bracket.