LEMON Manuals: Even more car manuals for everyone
Home >> Scion >> 2013 >> tC Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System (Service Information) >> Engine Coolant Temperature Sensor >> Inspection >> Inspection

Engine Coolant Temperature Sensor: Inspection: Inspection

  1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR 
    Fig 1: Inspecting Engine Coolant Temperature Sensor
    GTY312510Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    TEXT IN ILLUSTRATION

    *1 Resistance *2 Temperature
    *3 Acceptable Range - -
    *a Component without harness connected
    (Engine Coolant Temperature Sensor)    		 - -
    1. Partially immerse the sensor in water and warm up the water.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      1 - 2 20°C (68°F) 2.32 to 2.59 kΩ
      80°C (176°F) 0.310 to 0.326 kΩ
      NOTE:

      When checking the sensor in water, keep the terminals dry. After the check, wipe the sensor dry.

      If the result is not as specified, replace the engine coolant temperature sensor.

scientia non olet · About LEMON Manuals