DTC B2275: STSW Monitor Malfunction: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FOR DTC
1. Clear the DTCs. Refer to DTC CHECK / CLEAR .
2. Turn the power switch on (IG).
3. After 25 seconds have elapsed, check if the DTC has been set again.
  OK
  
  DTC B2285 is not output.
NG → See step 5

OK: Go to next step
CHECK HARNESS AND CONNECTOR (POWER SOURCE) See step 1
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR IN CIRCUIT CONNECTED TO POWER SOURCE

OK: Go to next step
CHECK HARNESS AND CONNECTOR (GROUND) See step 2
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR

OK → See step 4
REPLACE POWER MANAGEMENT CONTROL ECU. Refer to REMOVAL
GO TO DTC CHART (DTC B2285). Refer to DTC B2285: Steering Lock Position Signal Circuit Malfunction