Ignition Switch: Removal: Removal

WARNING:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column. Refer to PRECAUTION .

TURN FRONT WHEELS TO FACING STRAIGHT AHEAD
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
WARNING:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE STEERING PAD . Refer to REMOVAL - Step 2
REMOVE STEERING WHEEL ASSEMBLY . Refer to REMOVAL - Step 4
REMOVE STEERING COLUMN COVER (for Lower Side)
NOTE:
Removing the steering column cover in the incorrect order will cause the steering column cover to break.
1. Push the right and left sides of the steering column cove, and disengage the 4 claws.
  
  Fig 1: Identifying Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Insert fingers into the opening of the tilt lever of the steering column cover to disengage the claw.
  HINT:
  
  Spread the claw to disengage it.
  
  Fig 2: Identifying Lower Steering Column Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Turn the steering column cover to disengage the 2 claws and remove the steering column cover as shown in the illustration.
  
  Fig 3: Identifying Steering Column Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE IGNITION SWITCH ASSEMBLY
1. Disconnect the 2 connectors and remove the wire harness clamp.
  
  Fig 4: Locating Wire Harness Clamp Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 screws and remove the ignition switch assembly.
  
  Fig 5: Identifying Ignition Switch Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002