Fuel Pump: Removal: Removal

REMOVE REAR SEAT CUSHION WITH COVER PAD SUB-ASSEMBLY . Refer to REMOVAL - Step 1
REMOVE REAR SEAT UNDER TRAY COVER
1. Disengage the 3clips, 3 guides and remove the rear seat under tray cover.
  
  Fig 1: Identifying Rear Seat Under Tray Cover Clips And Guides
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
1. Remove the 5 bolts and bench type rear seat cushion.
  
  Fig 2: Identifying Rear Seat Cushion Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR DOOR SCUFF PLATE RH . Refer to REMOVAL - Step 15
REMOVE REAR DOOR SCUFF PLATE LH . Refer to REMOVAL - Step 16
REMOVE REAR FLOOR SERVICE HOLE COVER
1. Remove the rear floor service hole cover.
  
  Fig 3: Identifying Rear Floor Service Hole Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the connector.
  
  Fig 4: Identifying Connector To Fuel Pump Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
DISCHARGE FUEL SYSTEM PRESSURE
Refer to PRECAUTION
REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

Fig 5: Identifying Tube Joint Clip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Widen the tip of the tube joint clip and pull out the clip.
2. Pull out the fuel tank main tube to disconnect it.
  NOTE:
  - Keep the O-ring free of foreign matter, as it becomes contaminated easily.
  - Do not use any tools in this procedure.
  - Do not forcefully bend or twist the tube.
  - Put the tube in a plastic bag to prevent damage and contamination.
  - If the fuel suction plate and tube are stuck together, pinch the tube and turn it carefully to disconnect it.
  - Do not damage any clips. If a clip is damaged, replace it.
REMOVE FUEL PUMP GAUGE RETAINER

Fig 6: View Of Fuel Pump Gauge Retainer
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Using SST, remove the fuel pump gauge retainer.
  - SST: 09808-14020
    - 09808-01410
    - 09808-01420
    - 09808-01430
  HINT:
  
  Align the ribs of the fuel pump gauge retainer and the tips of SST.
REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

Fig 7: Identifying Fuel Suction With Pump And Gauge Tube Assembly
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Remove the fuel suction with pump and gauge tube assembly.
  NOTE:
  Do not bend the arm of the sender gauge.
2. Remove the fuel suction tube set gasket from the fuel tank.
  
  Fig 8: View Of Tube Set Gasket On Fuel Tank
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002