Cruise Main Indicator Light Circuit: Procedure
- PERFORM ACTIVE TEST USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Body Electrical / Combination Meter / Active Test.
- Check the CRUISE main indicator light by performing the Active Test.COMBINATION METER
Tester Display Test Part Control Range Diagnostic Note Indicat. Lamp Cruise CRUISE main indicator light Indicator light BLINK/OFF - OK
The indicator light blinks/goes off.
NG → See step 4
OK: Go to next step
- READ VALUE USING TECHSTREAM
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Cruise Control / Data List.
- According to the display on the Techstream, read the "Data List".CRUISE CONTROL
Tester Display Measurement Item/Range Normal Condition Diagnostic Note CCS Indicator M-CPU Cruise indicator signal (Main CPU)/ON or OFF ON: "CRUISE" on
OFF: "CRUISE" off- OK
When cruise control main switch operation is performed, the result will be same as above.
NG → See step 5
OK → See step 3
- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE
- REPLACE COMBINATION METER. Refer to REMOVAL
- REPLACE ECM. Refer to REMOVAL