Occupant Classification System: Registration: Registration
- REGISTRATION NOTE:
- If any DTCs related to the occupant classification ECU are output, troubleshoot those DTCs by referring to the DIAGNOSTIC TROUBLE CODE CHART.
- When ECU data saving or loading operations cannot be performed, replace the front seat cushion (with occupant classification ECU and occupant detection sensor).
HINT:
- When the occupant classification ECU is replaced, the previous ECU data must be saved in the Techstream and loaded into the new ECU by following the flowchart below.
- Until the data from the previous ECU are loaded into the new occupant classification ECU, these data are not erased even when the tester is turned off.
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Store the occupant classification ECU data in the Techstream by following the prompts on the tester screen.
HINT:
If the ECU data cannot be stored in the Techstream, replace the front seat cushion (with occupant classification ECU and occupant detection sensor).
- Turn the ignition switch to OFF.
- Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
- Replace the front seat cushion (occupant classification ECU and occupant detection sensor). Refer to REMOVAL .
- Connect the negative (-) terminal cable to the battery.
- Turn the ignition switch to ON.
- Load the data from the previous ECU stored in the tester into the newly installed ECU by following the prompts on the tester screen.
- Turn the ignition switch to OFF.
- Turn the ignition switch to ON.
- Clear the DTCs stored in the memory. Refer to DTC CHECK / CLEAR .
HINT:
If DTCs are not cleared at this time, past DTCs will remain.