Fail-Safe Chart

HINT:

If the following conditions are detected while the cruise control is in operation, the system clears the stored vehicle speed in the ECM and cancels the cruise control operation.

Vehicle Condition	Auto Cancel Condition	Re-operation Condition
CRUISE main indicator light blinks	There is open or short in stop light switch circuit There is problem with vehicle speed signal	Turn cruise control main switch on again
CRUISE main indicator light blinks	There is problem with input circuit of stop light switch circuit There is problem with cancel circuit	Turn cruise control main switch on again Turn ignition switch off then on again
CRUISE main indicator light remains on (Cruise control is canceled)	Under the following conditions, the stored vehicle speed is maintained: The vehicle speed is less than low speed limit (approximately 40 km/h (25 mph)) while running with cruise control on The VSC system is operated	Push cruise control main switch to + RES
	The vehicle speed is less than the stored speed by approximately 16 km/h (10 mph) or more	Push cruise control main switch to - SET
CRUISE main indicator light goes off	There is a problem with the throttle position sensor and motor	Turn cruise control main switch on again