Engine Control System (Service Information): ECM: Installation: Installation

1. Install the ECU bracket onto the ECM with the 2 screws.

   Torque: 3.0 N*m (31 kgf*cm, 27 in.*lbf) 

1. Temporarily install the ECM with the 5 bolts.
   Fig 1: Identifying ECM Bolts And Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   NOTE:

   If a component has been dropped or subjected to a strong impact, replace it.

2. Tighten the 4 bolts A to the specified torque. Then tighten bolt B to the specified torque.

   Bolt A 

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

   Bolt B 

   Torque: 13 N*m (127 kgf*cm, 10 ft.*lbf) 

3. Engage the clamp and connect the wire harness to the ECU bracket.
4. Pull down the lever to engage the lock and connect the 2 connectors to the ECM.
   Fig 2: Connecting ECM Connectors

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Engage the 2 claws and install the No. 1 air cleaner inlet.

Refer to INSTALLATION

Refer to PRECAUTION